Water Emergency? Tap to Call 24/7 — (972) 480-3940
Maintenance & Testing · North Texas

Protect Your Investment.
Catch Small Problems Before They're Big Ones.

A well that has run fine for years can fail without warning. Periodic maintenance is the cheapest insurance a well owner buys. We're TDLR-licensed and bring industrial-grade rigor from oil and gas drilling to residential water well care — we don't run checklists, we engineer maintenance to last.

TDLR Licensed #59822 · #60601
Written report you keep

What We Do

Three things, done right.

Periodic inspections

A real inspection isn't a glance at the wellhead. We look at every part of the system that fails — and keep records to spot changes year over year.

  • Wellhead & well-cap inspection
  • Casing condition where visible
  • Pressure tank air charge & bladder
  • Pressure switch & electrical
  • Written report you keep

Flow checks

Yield is the single best long-term indicator of well health. A flow check measures what your well actually delivers under load, against the original driller's log.

  • Sustained flow rate (GPM)
  • Drawdown and recovery
  • Pump motor amperage under load
  • Comparison vs. original log

A 25%+ decline in yield from the original log is the signal a well may need rehabilitation before yield failure becomes total.

Water quality testing

We collect samples and send them to a state-certified lab. You get a real report — not a strip dipped in a glass.

Coliform, nitrates, pH, TDS, plus expanded panels for iron, manganese, hardness, sulfate, chloride, arsenic, and fluoride where North Texas conditions call for it.

How Often You Should Test

Based on guidance from the National Ground Water Association, the EPA, and the Texas Water Development Board.

Every year
  • Coliform bacteria test (EPA minimum)
  • Nitrates test (critical near agriculture)
  • pH and total dissolved solids
  • Pump flow and amperage check
  • Pressure tank air charge
  • Wellhead and cap inspection
  • Electrical inspection
Every 2–3 years
  • Expanded panel — iron, manganese, hardness, sulfate, chloride
  • Woodbine wells: arsenic & fluoride (naturally elevated here)
  • Sanitary survey of the wellhead area
Every 5–10 years
  • Professional well camera inspection (casing, corrosion, screen)
  • Full pump performance test vs. original log
  • NGWA recommends a comprehensive inspection at least every 10 years even with no reported problems

Why It Matters When the Well Seems Fine

The cost argument

A waterlogged pressure tank caught at an inspection is a contained repair. The same failure discovered when it burns out the pump motor is a much bigger one — and a weekend without water waiting on parts. One inspection that catches one problem pays for itself for years.

The health argument

Coliform bacteria can enter through a cracked cap without changing taste, smell, or color. Nitrate can rise silently from agricultural runoff. The only way you find out is a test. Children, the elderly, and immunocompromised people face the highest risk from contamination nobody is watching for.

The property-value argument

A documented inspection history is an asset. When a well changes hands or a question comes up, having a paper trail makes the answer simple.

Water Quality Testing — What Matters in North Texas

North Texas wells draw from the Trinity and Woodbine aquifers, and both come with regional realities every well owner should understand.

Iron (Woodbine Aquifer)

USGS sampling shows 61% of Woodbine wells exceed the EPA secondary limit for iron. Rust staining, orange rings, metallic taste. Not a health risk, but a sign for filtration.

Sulfate (Woodbine)

61% of sampled wells exceed the secondary limit. High sulfate produces a bitter taste and, at concentration, laxative effects.

Nitrates (agricultural runoff)

A majority of shallow North Texas wells show nitrate above natural background. Above 10 mg/L is an EPA violation and a serious risk to infants. Annual nitrate testing is non-negotiable with small children.

Arsenic (Trinity, regional)

Naturally elevated in portions of the Trinity system. Texas well owners should include arsenic in any full-panel test, especially on wells deeper than 300 feet.

TestFrequencyWhy
Coliform / E. coliAnnuallyBacterial contamination from cap, casing, or runoff
NitratesAnnuallyAgricultural runoff; risk to infants
pH and TDSAnnuallyCasing corrosion indicator
Iron, manganese, hardnessEvery 2–3 yearsTreatment needs, fixture damage
Arsenic, sulfate, fluorideEvery 2–3 yearsRegional North Texas contaminants
Full panel (40+, VOCs)After repairs / any changeBaseline and incident response

DIY vs. Professional Maintenance

Safe for the homeowner

  • Visual inspection of the well cap (cracks, gaps, insects)
  • Verifying the wellhead sits 12+ inches above grade
  • Looking for wet spots around the wellhead
  • Keeping chemicals/fertilizer/pet waste 50+ ft away
  • Monitoring the pressure gauge for new short-cycling
  • Collecting a water sample for a certified lab

Never DIY

  • Removing the well cap or lowering anything into the casing
  • Adjusting the pressure switch (electrical burn hazard)
  • Pulling the pump (requires a rig and TDLR-licensed installer)
  • Shock chlorination without professional guidance
  • Any pump or wiring work (TDLR requires a licensed installer)

Symptoms Maintenance Catches Early

SymptomWhat it meansWhat annual maintenance prevents
Pump short-cyclingWaterlogged pressure tankBurned pump motor
Declining flow over yearsBiofouling, scaling, or drawdownCatastrophic yield failure
Pressure tank "thumping"Tank air charge bled downBladder rupture
Sediment in waterCasing corrosion or pump set too lowContamination event, casing failure
Elevated coliform countCracked cap or compromised casingPublic health event

Frequently Asked Questions

How often should a residential water well be inspected?

Annually, by a licensed professional. The NGWA and the EPA both recommend annual professional inspection plus annual water quality testing for coliform bacteria and nitrates.

What does a well inspection include?

Wellhead and cap visual inspection, pump flow test, motor amperage check, pressure tank air-charge verification, pressure switch inspection, electrical check, water sample collection, and a written report.

How often should I test my well water?

Coliform bacteria and nitrates annually (EPA recommendation). A full mineral panel including iron, sulfate, hardness, and arsenic every two to three years. Comprehensive testing after any system repairs or whenever the water taste, smell, or appearance changes.

What contaminants are common in North Texas well water?

Iron and sulfate in the Woodbine Aquifer (61% of sampled wells exceed EPA secondary limits). Nitrates from agricultural runoff in shallow wells. Naturally occurring arsenic in portions of the Trinity Aquifer, especially deeper wells. Hardness across the region.

Can I test my own well water at home?

Basic test strips exist but are not accurate enough to make decisions on. Use a state-certified lab. Texas AgriLife Extension can provide certified sample kits through your county extension office.

What is a pitless adapter and does it need maintenance?

The pitless adapter is the sanitary connection at the frost line where the water pipe exits the well casing toward your house. Inspect it every five to ten years and replace if it shows corrosion. February 2021 created widespread pitless-adapter failures across North Texas — anything older than that deserves a look.

How long do residential water wells last in Texas?

A properly maintained well casing can last 40 to 50 years or longer. Submersible pumps and pressure tanks typically last 10 to 15 years. With regular maintenance, all of those numbers go up.

Will testing my well water expose me to anything?

No. Lab tests are run on a small water sample we collect in a sterilized container. There's no risk to you, your family, or the well from being tested.

Do you service wells you didn't drill?

Yes. We maintain and inspect any residential water well in our service area, regardless of who drilled it.

What's the difference between rehabilitation and drilling a new well?

If yield has declined but the casing is structurally sound, the well is a candidate for rehabilitation — clearing biofouling, scaling, or screen plugging. If the casing has failed or the aquifer at that depth is depleted, a new well is the answer. We give you the honest comparison either way.

How do I get a copy of my original well log?

Texas well logs filed since 1986 are public record. We can pull yours from the TWDB well report database using your address. The original log tells us your well's depth, casing, yield at completion, and aquifer.

Already lost water?

Neglected maintenance is the #1 reason for emergency calls. If your well is down right now, see our 24/7 emergency service →

Emergency Service

Schedule Your Inspection

The cheapest insurance a well owner buys. Tell us about your well and we'll set up an inspection.

Dallas / 24-Hour Line

(972) 480-3940

Fort Worth

(817) 899-6531

Address

17330 Preston Rd, Suite 200D-208
Dallas, TX 75252

TDLR Licensed

Brad Butler #59822 · David Maynor #60601